For best results print one at a time. I had a number of print failures when attempting to print a plate with 3+ copies

used the additional orientation of the right bracket for a better fit using Plenty kitchen roll on original Skadis board

Excellent

Print came out fine but unfortunately was not suitable for my intended use - my thin scissors were too small and fell right through

Great design. For my installation I had to use the alternate right hand mount option. Check roll width before printing.

Excellent design, clean print in PLA (designer specifies PETG, but PLA worked great also). These mount extremely close together to maximise board usage. ‘lock’ nuts ensure a secure fit

Fantastic - made a great gift for my sons golf coach!

Fantastic for an end of year school gift

Great print. Well designed

Great design. Long print but worth it.

Great design

Strong

My mistake but be careful to follow instructions - had to print again as did not follow steps correctly.

Fun design

great fun and good print

Tall but good adhesion with textured plate

Printee in PETG. Print came out well

Pronted in SUNLU black PETG. Came out well

Magnets (15 x 3mm) keep this well attached. Great simple design and huge capacity.

Print came out great. Thanks