Printed in PETG and it came out great. I added a couple more drain holes in the bottom corners of the "stone" front plate and a ventilation hole at the top up under the roof. And blocked off the hole for the peg. Pegs are only of benefit to predators.

My wife loves them.

Fun design and printed fine after I opened it in Studio.

The surface was a little rough on the underside of one antler. I printed the first one with no supports and that was also a little rough under the belly. otherwise perfect both in PLA Plus and PLA Silk.

The yellow and orange came out muddy with the black shining through and black bleeding into the edges. The white was fine though. I even opened it in Studio and printed one stretched to 4mm in Z to make each layer thicker, with the same result. I guess I should have checked purge volumes etc before printing the second. For multicolor prints it is always best practice to make sure each layer starts with the lightest color then progressively darker. In this case, white, yellow, orange black, then start the next layer with white again. Printed on an A1 with Sunlu PLA plus. Love the design though.

Came out perfect and waa very useful to take on vacation.

Excellent print.

Excellent.

I had to print it at 102% to make it fit my A1

Works great. This is how bambu should have made it.

Looks good and works fine.

The first print is running now and so far it works great. You might want to include information on how to disassemble the original filament hub, as this was not inherently obvious and I had to search for this information. A video showing the replacement would have been more useful than a clip of your printer printing. Printed in black Bambulab PETG HF.

Fits great. Positively surprised that the TPU base snaps in and stays without glue.

The supports were an absolute pain on this print.