would be better if there was a locking mechanism when it was folded down

doesn’t spin long. spins for about 7 seconds

spinner pops out whenever. Pls try to make a locking mechanism.

bigger than I thought but still looks really good.

works perfectly

took about 20-30mins to take supports out

little bit too flexible

took a lot of filament to make

if does what it said it would do

printed a lot of these

that’s cute

that’s what I thought it would do

annoyed my brother also works as a fidget

the small and medium fabric were good but the large fabric spilt into a thousand pieces all around my 3d printer

it cuts tape good. But thankfully not enough to cut you tho. don’t know what else it prints off to the side.

works pretty good

mostly good hard to get back and legs in tho

cool

worked super good and still stays together after a lot of use and easy to load

little small