Very nice model. Thanks to the creator! Modded to hold DS cartridges.. then I went down a rabbit hole (it was arduous)..

Had to scale down a little for smaller glasses, but very nice design

Nice model. I ended up separating the pieces so I could easily print in 2 colors.

A nice design. Made a few small modifications to fit into my cabinet. Thank you for the model

Love this guy. Thank you for the model.

Very well designed. Relatively easy to print. The chain doesn't seem to stay attached to the eyelids piece, so I ended up gluing it. Wasn't sure if the top needed to be glued (quite loose), and I'm concerned if the top was glued, I wouldn't be able to get to the innards in case the chain had problems again.

AN easy print. Nice model. Thank you

Easy print. I couldn't get the cap screwed on completely, so I tweaked the dimensions slightly so the threads weren't so tight.

A nice and relatively basic holder for the HT. Simple print and a sturdy build. I modified the mounting bracket so that it would work with Sanja 3D's Riser & AMS Flipper for the P2S. Thank you for the model.

An easy print. I modified it to work with the P2S. Eyeballed it, and extended the piece that sits under the printer to 160mm (instead of 100mm) so it works with the P2S handles. Or, alternatively, just lengthen the entire piece. Thank you for the model.

Printed easily with PLA+. Pieces fit together tightly, (but that's as it should be) without any problems. I had to lengthen the legs a bit and modified it to a 3x2 size to fit my needs. Sturdy build. Thank you for the model.

Easy print. Works flawlessly. Thank you for the model.

A great model, and easy to print (once I got my printer calibrated properly)

AN easy print with ABS. Great model.

Nice design. I Just need to figure out if I cam somehow scale or modify it to fit a WD My Passport Ultra drive.

Simple print. As some have noticed, the tolerances on the lid are quite tight, it's hard to remove the lid the first Time but it loosened up after you keep putting the lid on and taking it off a few times (that or increase the scale to 100.7% for the lid)

Great model. Printed with no problems. I modified the case for my needs (deeper lid with compartments)

A good test for my new Cryogrip plate. Printed perfectly. The supports fell off very easily.

These are great for the kitchen drawers. Would like to half-bins made available :)

Great design, with an easy print. I didn't have pink filament, so ended up painting the ears and nose. Much prefer assembling parts instead of multi-color printing. Looking forward to new designs!