Firmly snaps into place and works a treat. Thank you

Print came out well. I still had issues removing the tubes using this tool :-(

It's a snug fit but it works and that's what counts. Thank you

Keeping the cable away from the spools. Nice design apart from the cable not sitting right in base, but that could just be how I've done it. Thank you

Nice design. Will be printing a few of these for storage. The grey box was printed using old filament so has a few flaws but the green one used new filament and is perfect. Thank you.

lovely design.closes firmly and pattern matches up. Thank you

Used esun filament PLA+3D,normal speed. no flaws. Thank you for sharing.

Used fresh roll of Sunlu PLA+ and came out flawlessly on normal speed