Search models, users, collections, and posts
Bio
Beginner printer and learning CAD.
Achievements
MakerWorld Guardian
This badge has expired
I could not find a 4 in 1 adapter that mounts to the backside of the H2 Series to work with the new filament switch. I remixed Bambu's original mount and designed PTFE 4 in 1 adapter holders that align to the inputs of the new filament switch for the H2 series.
PTFE 4-in-1 Adapter II for FTS Switch H2 Series
10
24
Share
0
0
0
Great model. Will not fit M4x6 screws - not long enough. I used x10 on the top piece and x16 on the bottom (x10 was too short for the bottom, x16 was what I had next).
Share
0
0
0
This thing is great!
Share
0
0
0
Surprisingly strong in PETG
Share
0
0
0
Fine, but could really use a 3/4 one in the set.
Share
0
0
0
Great print. Work as they should.
Share
0
0
0
Printed with ams tpu. Not as grippy as if I had used a softer tpu, but printed was perfect, and they will work well enough.
Share
0
0
0
Printed great. Amazing idea.
Share
0
0
0
I wanted something where I could edit the grit numbers and fit on multiboard.
5in Disk Sanding Holder MultiBoard Comp Adj Grits
5
5
Share
0
0
0
Share
0
0
0
You may want to put a 2-piece support block right above this or your multiboard will flex under the weight of the saw, but the print is perfect.
Share
0
0
0
I couldn't get my M3 nuts to fit, they were loose, so I used glue. I also used 5x2 magnets, for anyone curious. Looks and holds them great.
Share
0
0
0
Share
0
0
0
Been looking for this for a while. Well done.
Share
0
0
0
Share
0
0
0
Share
0
0
0
By FAR the best AMS desiccant holders out there. They fit perfectly, have the most volume, and are the easiest to fill. These are the ones to print.
Share
0
0
0
Holes in the back didn't align, had to get creative with a drill and heat press. Overall, great design.
Share
0
0
0