Search models, users, collections, and posts
Bio
Experienced printer and learning CAD.
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Wanting to use this amazing model, T-pose-slim dual AMS riser for H2D, H2S and H2C, I had to store my tools somewhere that were stored on my old AMS riser. A buddy and I designed and tested this model to allow you to attach MultiBoard panels that hang down the side of your printer. Right or left, universal fit. You should check out T-Pose's model and mine if you're interested in doing the same!
MultiBoard Mount for T-Pose dual AMS riser H2D/S/C
2
2
Share
0
0
0
I could not find a 4 in 1 adapter that mounts to the backside of the H2 Series to work with the new filament switch. I remixed Bambu's original mount and designed PTFE 4 in 1 adapter holders that align to the inputs of the new filament switch for the H2 series.
PTFE 4-in-1 Adapter II for FTS Switch H2 Series
38
153
Share
0
0
0
Great model. Will not fit M4x6 screws - not long enough. I used x10 on the top piece and x16 on the bottom (x10 was too short for the bottom, x16 was what I had next).
Share
0
0
0
This thing is great!
Share
0
0
0
Surprisingly strong in PETG
Share
0
0
0
Fine, but could really use a 3/4 one in the set.
Share
0
0
0
Great print. Work as they should.
Share
0
0
0
Printed with ams tpu. Not as grippy as if I had used a softer tpu, but printed was perfect, and they will work well enough.
Share
0
0
0
Printed great. Amazing idea.
Share
0
0
0
I wanted something where I could edit the grit numbers and fit on multiboard.
5in Disk Sanding Holder MultiBoard Comp Adj Grits
6
7
Share
0
0
0
Share
0
0
0
You may want to put a 2-piece support block right above this or your multiboard will flex under the weight of the saw, but the print is perfect.
Share
0
0
0
I couldn't get my M3 nuts to fit, they were loose, so I used glue. I also used 5x2 magnets, for anyone curious. Looks and holds them great.
Share
0
0
0
Share
0
0
0
Been looking for this for a while. Well done.
Share
0
0
0
Share
0
0
0
Share
0
0
0
By FAR the best AMS desiccant holders out there. They fit perfectly, have the most volume, and are the easiest to fill. These are the ones to print.
Share
0
0
0