small one is nice

just gluing magnets on but looks great

pretty good but I’d recommend printing barrel in petg as the elastic band catch on it as well as another part on the pistol grip broke. super satisfying print though I love to play with it.

Perfect for my Yugioh shrine! Pretty hard to put together though.

Sounds great and looks cool too. Tuning isn’t too hard either.

a slight bit rough but probably just my printer. bottom part might be a bit finicky to glue on. looks great though

This is hands down my most favourite print I’ve ever done. Ran out of grey filament halfway through but my P1P continued flawlessly with a new roll of filament. Used petg for the screws and dowels and it needs to be painted but I take my hat off to the designer. Love it.

printed perfectly with petg for joints and PLA for armour pieces. printed at 50% speed

Printed with PETG on P1P at 50% speed

supports worked great. at 100% speed on P1 no problem but in the last 20 minutes change to 50% as feet are harder to reach supports