If you've been planning to install a HEPA filter on the BambuLab X1C printer and have been hesitating about different solutions, here's an elegant one.

This frame is used to install a HEPA filter in the space above the carbon filter of the Bambulab X1C printer. Installation is simple and the filter is hidden.

The frame snaps into the space above the carbon filter. No need to disassemble the printer, no screw or glue needed. The frame only needs to be clicked correctly.

After installing the frame, insert the HEPA filter into the frame as far as it will go. The pull-out tab of the filter must point downwards, as you can see in the photo. Then insert the box with the carbon filter and snap the filter cover. Installation is complete.

The HEPA filter is a standard filter for robotic vacuum cleaners iLife V5 V5s V3 V3S V5S V50 Pro V55 X5. The size of the filter is 80x40x15mm. Fitr is cheap and easily available.

Here is a link to the filter:

Hepa Filter for Ilife V5

It is suitable to print the frame from PETG or ABS/ASA material. There is PETG in the preset profile.

Thank You!

NOTE: this was designed for the X1C printer, I have not tested with any other…