X1C/P1S Down Poop Chute - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

Tails

3D Printer>3D Printer Accessories

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

4.4 h

1 plate

4.9(14)

Open in Bambu Studio

Boost

124

167

103

Released

Description

Remix of X1C/P1S Poop Chute, following similar clip-on dimensions. I designed this so that my P1S sits at the front edge of an Ikea LACK table and deposits its poop to a bucket underneath.

The mount part is from the original design, and everything else is newly created here. The chute coming out is at 40 degrees instead of the original 45 in order to slightly extend the length to where I needed it.

poop chute

poop

printer poop

Comment & Rating (18)

@PlaceboXX

Print Profile

0.2mm layer, 2 walls, 15% infill

@Madmax.rs

Print Profile

0.2mm layer, 2 walls, 15% infill

Superb model I will soon upload my adapted version with a shortened ramp, as I do not have that much space on my shelf

Show original

@BiggN8Urz

can you share the shortened ramp.

(Edited)

@kickwriteteach

the existing screws don't fit. how do I attach this to my printer?

@strongerthanall

Print Profile

0.2mm layer, 2 walls, 15% infill

Worked very well - I wish there was a way to connect two or three X1Cs together using these connectors vs the flexi aquairum looking ones

@print_posse

absolutely love this. but anyway to add a extra horizontal piece? my trash can sits further up

(Edited)

@BiggN8Urz

Print Profile

0.2mm layer, 2 walls, 15% infill

works perfect for my setup

@Themizz039

Boosted

Has come in clutch on multi day prints. No more backups.

@Themizz039

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Nice print! it has really come in handy with the longer prints, Have a small trash under my bench so it’s been great not having to worry about a side mounted bucket filling up.

@Whit3Devil

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

printed without issue, fits well

@FC_Gibby

Print Profile

0.2mm layer, 2 walls, 15% infill

Other Issues:so the print file and print went perfect. only issue is that it should be noted that it will NOT fit with the AMS hub, which is what I would think most people would be using if they have an issue with a lot of poop dropping out the chute. oh well, to each their own