Search models, users, collections, and posts
AMS Lite holder for Aqara temperature and humidity sensor, no supports needed, only 3.5g, 17 minutes
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
17 min
1 plate
Open in Bambu Studio
Boost
4
8
2
0
4
5
Released
Description
Content has been automatically translated.
No supports, no glue required, direct assembly.
The tolerances are set relatively small, when assembling, push the cylinder into the square opening little by little until it is fully inserted, and the two parts will fit together firmly.
The dimensions of the temperature and humidity sensor I used are 36mm×36mm×9mm. If you need to adapt other sizes, please leave a message in the comments section, and I will modify the square part accordingly.
Boost Me (for free)
Thank you for supporting my work! This will encourage me to continue creating and sharing!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)