Search models, users, collections, and posts
Old Work Single Gang Box Cut Out Pattern
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
51 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
51 min
1 plate
Open in Bambu Studio
Boost
11
31
8
2
44
35
Released
Description
UPDATE:
I notice the hole was a little wide so I changed the width to account for this.
I got tired of tracing around old work boxes so I made a pattern.
This is for use with the single gang boxes that have the tabs that flip out inside the wall by turning the screws in the upper right and lower left corners.
An updated version will follow with a built in bubble level.
This is the very first design I have ever done. Enjoy. If you can use it, by all means, use it! Thank you for looking.
Please leave feedback and/or comments below.
License
This user content is licensed under a
Creative Commons Public Domain
Comment & Rating (8)