Clean KrakenBox – MTG Commander Deck Box

Original is a beautiful model with the Kraken design! You might want to print my remix for the reasons below. But please acknowledge the original creator with a Like and download because they did so much work to create the Kraken. Please boost either or both of us if you don't mind.

This remix improves the print in these ways:

1. Changed the bottom/top edges from rounded corners (fillets) to chamfers (45 degree cuts) because the original edges printed very poorly (see pics), whereas chamfers print cleanly. In general, for FDM printing, horizontal edges should always be chamfers, not fillets. See YouTube links below for the explanation of why. 
2. Added chamfers to the inner edges of the box, which where just sharp 90-degree corners before. This makes the box nicer to handle and the cards catch less going in and out.
3. Embedded a Plainswalker MTG logo into the top of the box to add a little “pop”. This requires an AMS, but a one-colour version without the PW logo is also included.

Versions included:

1. The first buildplate has the version with the Plainswalker logo. This requires an AMS and two colours. Set the PW inlay part to the colour you want for the log and set the top and base to your box colour.
2. The second buildplate has the one-colour version of the top and base. Can print on any printer.

See the Documentation section below for Tips & Tricks for Quality Prints. Very valuable if you're not a veteran. 

Green and Black filaments are linked in the BOM below. 

About Chamfers: