Gloomhaven Summoing Stone / JOTL - Scenario 4

A 3D model of the Summoning Stone required in Chapter 4 of "Gloomhaven - Jaws of the Lion".

The model is adapted to fit the stand figure trackers from againstyou, an 8x2mm magnet is needed for the model as well as for the figures. Four 8x2mm magnets are therefore also needed for the four stones required. These are simply pressed into the stone from below (note the polarity of the magnets). An AMS is not absolutely necessary, as the filament change is carried out at a layer height. This can also be done manually. The layer height of the model is 0.2mm for the base and 0.08mm for the stone to better highlight the details. The runes can be colored with a colored marker pen or model making acrylic paint. A color change via AMS is not very sensible, as it is too small.

I used the model from Spinodal_Zeugma as the summoning stone, I liked this one very much.