Search models, users, collections, and posts
CR-10 V3 Filament guide with flanged bearings
IP Report
Print Profile(1)
0.08mm layer, 13 walls, 15% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
1
2
0
0
3
0
Released
Description
Summary
Hello, this is a custom design for the cr10 v3 that allows to use bearings to guide the filament into the sensor without much/any friction.
I used some flanged bearings I had around.
When printing the pins, I suggest you scale it to 98-99% in the slicer to make it fit.
To remove the pins, you actually have to use a wood screw, screw it half and pull, or just make your own cilinders with a better design!
You'll have to use longer screws than original ones to mount it to the metal frame.
https://youtu.be/jNjfuIqy_W8
Print Settings
Rafts:
No
Supports:
Yes
Resolution:
.2mm
Infill:
25
Filament:
pla pla+
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)