VINDSTYRKA Wall Mount (Ikea Air Quality Sensor)

I know this is a very “me” problem, but I needed to mount my Ikea air quality sensor on the wall to gain some room on my desk, so I designed one.

It is not fancy, but it does the job. It was meant to be stuck to the wall with double sided table, and the funny thing is that it turns out to be exactly the size of command strips, so there's that … but any double sided tape should work fine. I can probably make a screw hole verions if you so desire :)

I did not find a good way to print this without support, but if you put it inside of the holder's recess, where the device goes, you will never see it. 

I printed it in PLA with 3 walls (because I'm a bit of a psycho), but 2 would probably do just fine. 15% Gyroid infill because why not. Feel free to experiment.

No Vindstryrka were harmed in the making of the wall mount. 

I am personally very happy with the way it turned out, I hope this can be useful to someone else as well.

Cheers!