Moment Lens Cases

FOLLOW me for new updates and models - https://makerworld.com/en/@menerso 

Update 10-20-25

• I added a single case for the Anamorphic lens by itself

  

Update 10-19-20

• I added a new set of STL files that fit just a single Moment Wide V2 lens
   

  

Update 01-02-19

• I added a new set of STL files that fit the new Moment Telephoto lens (it is bigger)
• The width is 4 mm wider than than v2 one.

Update v2:

• I removed the back two holes for the magnets ( not needed with the hinge )
• reduced the fillet around the top and bottom edge from 3mm to 2mm.

Summary:
Moment makes lens for iPhones and Android phones. I have the Wide, Telephoto and Anamorphic lens with their lens brush also. I love their products.

I made a simple case to carry everything so that I don't have to worry about losing any of the pieces.

I tried to make the case as small and tight as I can without a lot of wasted space.

To attach the cover, just place both parts together standing up on its front. Then just "smack" the cover down into the base and viola, the top is now attached.

I put some holes in the cap and base to use small magnets to hold top shut. I put three in, but I only use the front one because that is all that is needed to hold it closed.

Post-Printing

Attaching the top is a piece of case. Hold them together and smack it down.

As for attaching the 1/4 in x 1/16 in magnets, you can use glue or some 3M two-sided tape.

https://www.amazon.com/Universal-Magnets-Magnetic-Organizers-Fasteners/dp/B077YT1X5F/ref=sr\_1\_3?ie=UTF8&qid=1544582199&sr=8-3&keywords=1%2F4+1%2F16+magnets 

Check out my other models and Collections.  Why not give me a FOLLOW since you are there.

I post new models and updates to models frequently.