Green Cheek Conure - wall smash - Hueforge

Meet ollie - My little, keyboard munching, house trashing, wrecking ball of feathers! Who is also my little best friend and emotional support buddy! - This also sums up every conure in the world. 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.56mm
The Max Depth is 2.9mm and the Actual Depth is 2.6mm

Filaments Used:
    PLA Kingroon Black 
    PLA Kingroon Red 
    PLA Kingroon Gray 
    PLA BambuLab Basic Yellow 
    PLA Kingroon White 
This print uses 5 unique filaments

Swap Instructions:
    Start with Black
    At layer #11 (0.96mm) swap to Red
    At layer #13 (1.12mm) swap to Gray
    At layer #15 (1.28mm) swap to Black
    At layer #17 (1.44mm) swap to Yellow
    At layer #19 (1.6mm) swap to White
    At layer #21 (1.76mm) swap to Gray
    At layer #23 (1.92mm) swap to Black
    At layer #26 (2.16mm) swap to White for the rest.