Search models, users, collections, and posts
Rain water trap seal 80mm
IP Report
Print Profile(1)
PLA 0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
1
9
0
0
4
1
Released
Description
We have installed a leaf extractor on the rainwater pipe connecting our gutter to the sewer. This was needed because else leaves would block the pipe. Now we have a new problem, a sewer scented backyard. This is my first attempt to install some kind of trap seal.
I will need to print this in PETG or ASA I guess but this prototype is done in PLA.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)