Search models, users, collections, and posts
VTECH baby monitor stand- Under 20 grams!
IP Report
Print Profile(2)
SINGLE COLOUR
Designer
1.2 h
1 plate
0.2mm layer, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
40
146
42
12
288
231
Released
Description
The kickstand for our VTECH baby monitor has been broken for ages. I finally got fed up with propping it up and made this!
It was designed in a way to still allow use of the antenna.
To install: Remove the original kickstand completely. Clip the bottom side then the top. It is tight but it fits perfectly. The flap is snap fit and requires a small amount of force.
1hr 16 minutes to print both parts. Supports use less than 3 grams and the model is 16 grams for a total of under 20 grams!
Happy printing!
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (42)