ZX Spectrum Multiface One Replacement Case

Replacement Case for the Multiface One. Best printed at 0.16mm layer height or less for the slant. Includes space for a label and I've included a scan of the original Multiface One label to use if you want.

Should be laid flat to print, not printed in the vertical orientation.

The assembly is a little different to the original to make it easier to print. The top is now just a lid and needs gluing to the bottom to secure. The original case screws are used to secure the PCB to the bottom of the case only. There is also an insert which needs to be placed on top of the PCB before putting into the case and the top adding. This stops the PCB rocking when plugging into the Spectrum. Something similar was on the original but part of the top of the case.