Search models, users, collections, and posts
Garland/Light Clip
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
19 min
1 plate
Ready to print | 0.2mm layer, 2 walls, 15% infill
25 min
1 plate
Open in Bambu Studio
Boost
11
35
3
0
53
28
Released
Description
Inspired by the light hooks that command makes, this version is a little bigger to accommodate a garland/light combo. I could also see this being used to organize general cords/cables (might need scaled up a bit for that). Supports are not needed if you orient it so it's standing up like in the cover photo. To hang you can use either command strips or double sided tape.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)