Mimikyu AMS Remixed by mateocray

Remixed by

mateocray

Art>Other Art Models

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.16mm layer, 2 walls, 15% infill

Designer

12.2 h

1 plate

4.2(6)

Open in Bambu Studio

Boost

Released

Description

I downsized and painted a mimikyu model made by ClassyGoat on thingiverse

uses red, black, and yellow filament. 2 ½ inches tall

Mimikyu by ClassyGoat - Thingiverse

pokemon

mimikyu

Comment & Rating (6)

@KillaPrintzilla

Print Profile

0.16mm layer, 2 walls, 15% infill

Scaled up a bit, made with glow.in the dark for an off white look that I think turn out amazing. my only issue was brim from the tree supports sticking to the base but some plyers and patience paid off!

(Edited)

@DwergBerg

Print Profile

0.16mm layer, 2 walls, 15% infill

scaled it down even more. made the tail point a bit weaker and broke off. very heavy fillament usage when only printing one with AMS. Fill your plate and print a bunch to save on fillament waste ;)

@rattytaty19

Print Profile

0.16mm layer, 2 walls, 15% infill

Might have been cute, but took a long time and it was Already starting to mess up on the third hour

@TowboatShaggy

Boosted

Print Profile

0.16mm layer, 2 walls, 15% infill

Strength Issue:Overall the Mimikyu is great. However even scaled up the tail ended up snapping off mid-print. i managed to save it by printing just the tail but even that was a pain as it fell over even with a brim. I recommend draeing on supports under the tail to add to the rigidity.