Small village square - Large Paver Floor OpenLOCK

After the large village square, I needed smaller paths leading up to the center. Therefor a small curved corner that can be a little village square when you combine 4.

Remix of devonjones's OpenForge 2.0 Building Facades: Large Paver Floors

With the Openlock triplex base you can click the tiles together in a limitless configuration of your choice.

I added aditional beams, because I found that printing the big ones without them doesn't always give the best texture at the bottom. And if I put the time and money in tiles, I want them to be pretty and sturdy.

Instructions:

• Print the tiles of your choice. In this case the whole town square is the 1 plate.
• Remove the small supporting pins on the sides.
• Print Openlock clips to connect the tiles.
• Push one or more Openlock clips into the tiles (depending on the size of the tile 1 can be enough, 2 works best with big tiles).
• Connect the tiles together.

The designer of the totally free, awesome and VERY complete series is Devon Jones, check out his profile => https://www.thingiverse.com/devonjones/designs

Together 3D has a commercial license for using the OpenLOCK system. More info can be found on www.printablescenery.com