Search models, users, collections, and posts
24mm Expandable Dowel Rod
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
2.6 h
1 plate
Open in Bambu Studio
Boost
73
212
13
5
370
164
Released
Description
I was printing the Filament Bracket by waleriusDesign and I didn't want to go buy dowels because I'm cheap and I have a 3d printer - and I know I'm not the only one! Hopefully this can be helpful!
The included plate is composed of 3 mid sections, 1 male, and 1 female end. This totals 710mm (just under 28 inches). You can print as many mid sections as you need 225 mm/ ~9 inches each.
Designed to be printed with NO supports. Flat on the bottom to make this possible. Its not the fastest print, but you could speed it up by using 2 walls instead of 3 at the cost of strength.
Designed for the above print at 24mm, but could easily be scaled up or down to be any size you need. Maybe.
Happy Printing!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (13)