T.Rex Skeleton Strengthened support stand

This is a remix of Reinforced T.rex Skeleton by Encrust3d. Reinforced T. rex Skeleton - fixed Remixed by Encrust3d - MakerWorld

I found that over time the support stand was bending slightly. I added a part (Strengthener) that slips over the support stand (Base Beam).

(See v2 profile modifications for the even more stable stand and base).

The fully assembles size is aprox - L=57cm  H=28cm

I rearranged objects on the plates For P1s.

if you have any printing problems printing, try printing the troublesome parts one at a time, less chance of spaghetti.

I have added profile to put the claws on a separate plate. 

I would also advise using a Cryogrip build plate, models stick to it better than the Textured PEI build plate.