Reinforced T. rex Skeleton - fixed

Remixed by
Copyright Claim

Reinforced T. rex Skeleton - fixed

Remixed by
Boost
195
290
14

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.16mm layer, 2 walls, 20% infill
0.16mm layer, 2 walls, 20% infill
Designer
20.3 h
4 plates
4.6(12)

Boost
195
290
14
1
504
467
Released

Description

 

This is a remix of the T. rex skeleton from Makerbot. When I printed this, there were a few things I really did not like about the design, so I made some changes. When I was assembling the skeleton, the ribs could constantly fall out at the slightest touch. The design for some of the ribs had one or two .4mm layers as the clips, which made them break super easily and were very prone to falling out. I reinforced all of the ribs to ensure no glue was needed to keep them in place. Another thing I did not like was how the T. rex was pretty much facing down. I edited the base beam to make the T. rex look up some, while still being able to balance on the base. Here is a before and after picture with the original beam and the beam I redesigned.

This print does need supports on some pieces to print properly. The .3mf I uploaded has supports where needed and support blockers where no support is needed, but the slicer wants to add them anyways. Some glue may still be required to properly connect the neck and tail pieces.

 

Assembly Instructions can be found here:

Comment & Rating (14)

Please fill in your opinion
(0/5000)

Print Profile
0.16mm layer, 2 walls, 20% infill
After a couple adhesion issues and reprints it came out great. Looks great!
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
It was fun to do,ty
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
worked great but i resliced it
0
Reply
模型是错误的
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
the print went very very well, the only big headache is the damn ripcage that turns into a nightmare puzzle due to loosing the numbering below, other than that is a really nice print!
(Edited)
0
Reply
It looks insane! I'll print it for sure. As a present for my 13 years old son. Thank you! What tool you've used for designing, Rhino?
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
Bed Adhesion Issue:i try 5 time, 2 whit the glue
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
0
Reply