Search models, users, collections, and posts
Honeywell/Intermec PM43/PM45 label holder clip
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
Open in Bambu Studio
Boost
4
5
1
0
19
8
Released
Description
This is the Honeywell/Intermec PM43, PM45, PM43c and PM45c label holding clamp that is used to hold the labels in place
I ran into an issue at my work where the clips would constantly break overtime, I found the original file on Cults3D and it was almost perfect for the label holding bar, I had purchased the file and removed the conflicting ledge and it worked amazingly!
In one of the photos I circled the conflicting ledge I had talked about
Comment & Rating (1)