Search models, users, collections, and posts
Mount for Ender-3 V3 SE-KE Filament Runout Sensor
IP Report
Print Profile(1)
PETG, 0.2mm layer, 5 walls, 30% infill
Designer
2.1 h
1 plate
Open in Bambu Studio
Boost
98
185
9
2
375
34
Released
Bill of Materials
List other parts
- M3x14-Schrauben x 2:
Description
Content has been automatically translated.
Printed with SunLu PETG
The original filament runout sensor mount hangs too high for me. I have too much leftover filament going to waste.
Therefore, I developed one that attaches to the print head. However, I can still comfortably access it to insert or remove new filament.
The mount is attached to the cable clamp of the print head. The plastic part used to clamp the cable must remain. Only replace the screws.
A pair of new M3x14 screws are needed, as the originals are too short.
This mount was printed on the Bambulab P1S, as the Ender-3 was currently disassembled.
Boost Me (for free)
A boost would of course be appreciated. It motivates creators to publish their models.
Thank you.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (9)