Swiss Railway Desk Clock - Components Kit 011

This 3D printable model is a tribute to the iconic Swiss Railway clock, designed to perfectly fit the Clock Components Kit 011. With its clean lines and classic design, this case brings a touch of timeless Swiss precision. It’s easy to print and assemble—no extra parts needed besides the kit itself.

You do not need AMS to print this model, and even a basic A1 mini printer can handle the whole thing, including the two-color clock face. The hour and minute markings are applied (raised), so you can just pause at layer 13, swap the filament manually, and then resume. If you're using Bambu Studio, check out this thread for how to pause for a manual filament change.

If you are looking for something different, check out my other clock models linked below. All of the parts are interchangeable with other clock models of the same size, in case you are looking to mix things up:

• 90mm Desk Clocks:
  • Apple iPhone Desk Clock
  • Swiss Railway Desk Clock
• 175mm Wall Clocks:
  • Apple iPhone Wall Clock
  • German Railway Wall Clock
  • Swiss Railway Wall Clock
• 250mm Wall Clocks
  • Apple iPhone Wall Clock
  • German Railway Wall Clock
  • Swiss Railway Wall Clock

Assembly Instructions

1. Insert the clock mechanism into the slot on the back of the back plate, making sure it is fully seated. Attach the thin brass nut onto the post protruding from the front of the back plate and tighten it.
2. Align the clock face with the outer case and press it in. Then, push the back plate into the outer case to secure the clock face. Ensure the snap-fit closes securely on all four sides.
3. Start by attaching the hour hand, pushing it onto the larger part of the post until it’s snug (but don’t use excessive force). Then, attach the minute hand onto the smaller part of the post. For the second hand, remove the small pin piece from the kit’s second hand. Push the pin through the printed second hand, and insert the pin into the hole at the end of the mechanism post. Make sure all hands move freely without touching each other.
4. Insert the battery into the mechanism and set the time.

Filament Notes

I printed this model using black PLA-CF for the outer case, back plate, hour hand, and minutes hand, and red matte PLA for the seconds hand. The clock face is dual color, with the base in white PLA basic and the applied hour and minute markings in black PLA-CF filament.

Disclaimer: This model has been shared for non-commercial, personal use only.