Snausages Dog Poop Bag Dispenser

This is a dog poo bag dispenser modeled after the Snausages Dog Treat cartoon dog. I used our talking Snausages Dog Cookie Jar as a model. The dispenser is a 2-piece design so all you need to do is slide the feet off to load a roll of poop bags. The diameter of the opening for the roll is 35mm and 65mm deep which will accommodate standard sized rolls of poo bags.

To load, remove the feet and insert the roll leaving a little bit of the first bag sticking out as shown in the picture. Roll it a bit like you were closing the bag of a loaf of bread and insert the rolled part out the dog's butt slot. While holding the end of the bag in the slot, slide the feet back on. The feet are designed as a tight fit so as not to come loose so you need to take a little care you are sliding it on with both tracks in place and sliding it straight.

SECRET TEETH! If you have a 0.2mm nozzle and want to print the teeth outline, go into objects and locate the teeth parts that are colored white and change them to black. They don't really print well with a 0.4mm nozzle due to their small size, but look good in 0.2mm.

The loop on top is 6.4mm thick (¼") and ring/hook/carabiner up to 8mm in diameter will pass through the opening.

NOTE: I have the feet on a separate plate because of the adaptive layering on the dog body. Feel free to mess with it but I have it dialed in for good resolution of the eyes and the text on the collar.