Search models, users, collections, and posts
WDT Tool + Filament as pins
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
46 min
1 plate
Open in Bambu Studio
Boost
39
85
3
3
138
64
Released
Description
Simple WDT that uses any 1.75mm filament as the prongs. Simply cut to desired length and press fir into the holes.
If you would like your filament nice and straight, a good tip is to soak it in hot water (boiling) until soft like spaghetti and then lift it out with some tongs.
Happy Printing
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)