Amolen/Locyfens 200g AMS Adapter Spool

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
NEW, MORE COMPATIBLE VERSION ONLINE, CHECK →
Spoolmate AMS – The Ultimate 200g Spool Adapter
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

------------------------------------------------------------------------------------------------------------------------------------------------

Amolen & Locyfens 200g Spool Adapter for AMS
 

Background:
As I often purchase Amolen color packs, which come in 200g spools, I needed a straightforward, sturdy, and reliable adapter for my AMS. Unfortunately, I was never completely satisfied with the designs released so far, so I took the best aspects from all designs and created an entirely new adapter.
 

Here is my attempt to develop the best spool adapter for using Amolen 200g spools in the AMS.

 

Design:
Both adapter plates are equipped with 4 fixing points each, which fit into the existing holes of Amolen spools. This prevents the spool from slipping within the adapter. Additionally, both adapter plates are screwed together, which clamps the spool securely and keeps the fixing points on the spool.


Filament Clip:

Since i don't like to bend my Filament to hold it in place, i left the typical holes out and designed my adapters to fit the "Not another Filament Clips" by Brent Peterson, which are intended for the original Bambulab spools.

 

After Print:
You need to loosen the screw and thread a bit initially. Directly after printing, they might be a bit stiff since the threads have minimal play. This allows for clean tightening even after repeated use.
 

ATTENTION:
Amolen seems to use several different spool types. One fits perfectly into my adapter, but with the other, the holes are a bit closer together, making it not fit the adapter right away. The User “sixty5low” has found a pragmatic solution here—you just need to cut off one pin for each, thanks for that! You can see pictures of his solution in the comments. If the Adapter doesn't fit anyway (last happened with some Amazon Spools) give me some measurements and i will redesign the adapter :) 

 

Closing Words:
I would greatly appreciate feedback, and if you have any questions, issues, or suggestions, feel free to share them! :)