Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
8
27
2
0
18
12
Released
Description
Summary
Cable holder for IKEA BEKANT table where only the cable holder is visible from above and no glue or penetrating screws are involved. Not perfect, but works.
Print Settings
Printer:
Bambulabs A1 mini
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
15%
Filament:
eSun PLA+, white
Post-Printing
Instructions
1. Connect the two pieces (I used a pipe wrench and sth. to protect the surface)
2. Loosen IKEA BEKANT side screw 1-3mm
3. Slide the cable holder over the screw
4. Fasten the screw again
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (2)