Very Annoying 216 Screw Gift Box

EDIT: I have a new box design out now!

EDIT: I now have a simpler and smaller version made to fit gift cards and money.

EDIT: I made a mistake on the screw count on the print profile. I have rectified that. I have also added a dot to the ends of the reverse screws to tell them apart from regular ones.

I wanted to make my own version of an annoying gift box, but make it much worse.

The box was designed to perfectly fit one of my other design, a MTG commander deck box, inside but can be used without it.

The internal dimensions of the box is 77mm x 77mm x 96mm.

There are a few factors that make this box more annoying than some others I've seen posted.

1. There are 216 screws on the giftbox.
2. The second layer to be removed has a special triangle bit needed to remove the screws compared to the rest that uses a flathead design. The screws can be randomized to make it even more annoying, but I decided to dedicate a layer of screws to it to simplify printing and assembly. The models for short variants of the triangle bit screws are given in the raw files.
3. In addition to normal screws, there are many that are reverse thread (rightly loosey instead of lefty loosey) and there are 16 spots for a captive screw that will spin in place but will not be removed. This brings the total of screws needed to be removed down to 200 instead of 216.

The box is separated into 4 layers.

1. Ribbon
   1. 4 ribbon pieces
   2. 20 long screws (on the bottom)
   3. 20 long screws with reverse threads (on the top)
   4. a flathead bow/screwdriver
   5. a triangle bow\screwdriver broken into 2 pieces to print better
   6. a bow stand
2. Outer Box
   1. 2 outer box pieces
   2. 40 long triangle bit screws
      1. 6 of these will be captive screws (see attachment for placement)
   3. 8 long triangle bit screws with reversed threads (see attachment for placement)
3. Inner Box
   1. 2 inner box pieces
   2. 90 short screws
      1. 10 of these will be captive screws (see attachment for placement)
   3. 38 short screws with reversed thread (see attachment for placement)
4. Screw Frame
   1. a box frame
   2. a box base piece (all regular thread)
   3. a box lid (all reversed thread)
   4. 16 nuts to keep some screws captive