Bambu Lab P1S/P1P iPhone Holder - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

butcher9_9

3D Printer>3D Printer Accessories

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

1.2 h

1 plate

5.0(4)

Open in Bambu Studio

Boost

Released

Description

A Remix of SkyGuys great iPhone stand for the P1P.

This version has a few differences:

Easier to print.

Internal cable management.

Does not block the top from having a panel installed.

Supports P1S.

Supports the same phones.

Support is needed for the base but its very minor, I did try a sacrificial bridge but was harder to remove than support and made installing the screw harder.

2X M3 countersunk screws from 6-12mm to attach the screen to stand and a 10+mm M3 screw (button head or one of the screws used to secure the machine in shipping works too)

*** Its important to thread the cable through the hole in the top first, then through the base before screwing it down, then the stand and then screw on the case back. Don't over torque the base screw as its just in plastic and will strip ***

*** Another important thing to note is that you make sure the bit screwed into inside the machine is facing away from the print head or it will trigger a “ face plate has come off error” ***