AMS lite wallmount option for small enclosures

Update: because many people have asked for it, I have added another print profile. This contains the holder for the spool including the frame for the RFID spool so that the RFID function is retained. You just print 4 of them instead of the Plate 1. However, depending on the arrangement, the cables will be too short and will have to be extended. The RFID coil can simply be fixed in place with hot glue

Hey guys,

I dont have much space in my appartement and my printer is placed in a little cabinet in the kitchen, which isnt big enough to fit the AMS lite as well. So I had to come up with a new concept. Maybe some of you have the same problem and may need a solution like this too.

You can print all parts you need. And also can reuse all the parts of your ams lite as well.

Printplate 1 holds the attachment for the tubes holding the spools. You can just take them from the AMS lite, get them in thightly with a hammer, drill some holes (4mm) through the 2 holes at the sides and secure them with 2x M4x20 screws and nuts each (8x screws and nuts).

Then you just need 14x M4x20 countersunk head screw to get them to the wall

The second build plate holds the casing for the circuit board and the motors. Here you only need 7x M3x10 countersunk head screw to get them to the wall. All the other srews you need are the srews you get while disassembling the AMS lite.

(I rebuild the tubes, which hold the spools, because I didnt want to drill into the originals. In case you want to do it like this too, you need to buy tubes with the exact inner and outer diameter as the originals in your hardware store. Then you need to reprint the snapping mechanism on Plate 3
Tube measurements: inner diameter 16mm, outer diamater 18mm, length 77mm)

I hope I didnt forget any crucial information.

If you need help or have any problems while assembling or printing, please feel free to write a comment.