Naughty, Nice, An attempt was made (Just saying)

Naughty, Nice, An attempt was made (Just saying lol)

This is a fun(ny) file that has the added value of filling 2 needs this Holiday Season- What to put on the tree (Ornament) and How are we decorating packages & will get you a chortle or two no matter how you choose to use the file.

This is set to print face down AND yes, there are 2 versions of the file included: not mirrored (backside blank) printed face down , and then one file that is mirrored (text on the front and back)

*** these all can be edited as all parts are OBJ and COLORS can be swapped ( the combinations are only limited by your filament color options) even if you are not an Intermediate/Advance 3D artist

P1P/ P1S Bambu Basic settings

Aux fan recommended to be at or below 20% or turned OFF (if using one)**this is only a suggestion as YOUR settings that work best for your material should be used

Size is 3.28x3.75x.15 (this can be sized up a little or sized down a small bit)
(print more to make the time worth it and the poop results across multiple prints will be less)

Settings are default for P1P .04 unless stated below:
This is set to print face down-the there are 2 versions Mirrored (same text front and back) and then face down (blank on back)

Print order of color has been locked down as well

Ironing is turned on for top surfaces
Wall Generator is Arachne
5 top/5 bottom shell layers
20% Gyroid infill
18% Infill/wall overlap
Initial Layer 35mm
Initial Layer Infill 90mm
NO support/NO BRIM

Prime tower enabled **suggest it be used 
Brim/Bed Adhesion: None Needed
Flushing set at default **you will need to adjust this for your filaments and machine type and how dialed in your settings are