10mm laser honeycomb Standoff clips for 3,4,6mm

10mm Standoff clips for laser honeycomb for 3,4,6mm material.

The distance is for putting under the material if you want tro prevent itt to fall down but make sure the laser wont hit them.

Raises the material 10mm of the honeycomb. 
I printed in eSun pla+ but i beleve most plastic would work.

I have a xTool s1 but i guess it will work with other honeycombs as well as long the hole size are bigger then 9.5mm.

For the original model for 10mm hole in the honeycomb with a more sturdy top of 3mm look under folder “Honeycomb with 10mm hole standard” this is the one i usee for my Xtool S1 honeycombe

I have added a model with a more low profile top for lasers that goes tight against the material, look under folder “Honeycomb with 10mm hole Low profile just 1mm over material” se pictures.

I have added a model for with 7mm honeycomb pin (not tested but let me know if its to wide in the base and i will fix it)
Look under folder “7mm Honeycomb pin” see pictures.

I have added a model for with 6mm honeycomb pin (not tested but let me know if its to wide in the base and i will fix it)
Look under folder “6mm Honeycomb pin” see pictures.

I have added a model for with 4,5mm honeycomb pin (not tested but let me know if its to wide in the base and i will fix it)
Look under folder “4point5 mm Honeycomb pin” see pictures.

I have added a model for with 8mm honeycomb pin (not tested but let me know if its to wide in the base and i will fix it)
Look under folder “8mm Honeycomb pin” see pictures.