Search models, users, collections, and posts
Panda PWR Interlocking Rear Mount - Remix
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.6 h
1 plate
Open in Bambu Studio
Boost
17
43
19
3
77
53
Released
Description
This is a remix of Bigtreetech Panda PWR Interlocking Rear Mount by Shadowtrance which is a great model - this remix consist of minor changes to the model only:
- Added some "gussets" and some "in-model" support structure, this, combined with another printing orientation allowed for printing with no "slicer-added" support.
- I also did some minor changes to the "truss" design to reduce material usage...
None of these changes are really needed at all... :P but it results in a reduction of approx 24% filament usage and approx 33% shorter print time - which always is a win in my book :-)
The "in-model" supports just snaps of - you may want to trim the break-off area with knife or deburring tool if you want it completely smooth.
STEP-file attached.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (19)