Kids Modular Carwash

This is a modular carwash that you can print for your kids to wash hotwheels or other smaller 3d printed cars. The brushes are to be printed in TPU without support and you must use an xacto blade or other knife to cut away the outer circle. The holes in the road part are big enough for straws to fit in (we used reusable plastic straws). The yellow “drying” pads are small foam sponges that can be bought on Amazon or a local craft store. The “water” and red overhead “brushes” are foam sheets cut to fit around the straws, again can be bought on Amazon. The road pieces need to be printed with supports to ensure proper fitment. The orange caps may be a little tight, but I didn't want little ones to hurt themselves if they accidentally take one orange topper off and fall on a hard straw. This can easily be broken down to fit in a drawer. The road has interlocking pieces, which should not be an issue with fitment, even if your printer is not calibrated.