Search models, users, collections, and posts
Spray Booth Air Regulator Holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
0
4
0
0
13
6
Released
Description
This is just a simple Spray Booth Air Regulator wall holder for an air line regulator/water trap.
No supports are needed and it takes 1 hour and 54 minutes in standard mode to print. I printed it on sport mode at 10% infill with no issues, as pictured above.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)