STEMMA QT & QT Py Sewable Clips

Slap those Adafruit sensors and QT Py's, Adafruit's “diminutive dev board”, to all sorts of fashion accessories! These 3D printable clips allow you to sew on an Adafruit QT Py or an Adafruit STEMMA QT form factor sensor.

There's two versions, for the QT Py clip, tabs or no tabs. Tabs allows for better wire management, as seen in the photo above, but go for no tabs for a smaller, cleaner, footprint. The clips snap-in, so I wouldn't use silk PLA, but it worked for me. In the photos above I used PETG for the extra durability and little bit of give.

Let me know if you want other footprints for your monstrous mounting ideas!

(Sorry about the dark photos, I didn't think I would need any lighting!)

Note: This does not fit ALL Adafruit sensors! Some may be chonkier, slimmer, or just plain weird. But in my experience most STEMMA QT (not analog, 1 wire, CAN, etc.) Adafruit sensors fit.

Big thank you to the Ruiz Brothers, their AMAZING Adafruit 3D models helped make these a reality. Check out their stuff too!