Bambu Riser by SSSR_SH

SSSR_SH

3D Printer>3D Printer Accessories

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

0.28mm layer, 2 walls, 15% infill

Designer

20.2 h

4 plates

0.28mm layer, 2 walls, 15% infill

Designer

11.1 h

4 plates

0.2mm layer, 3 walls, 15% infill

Designer

3.1 h

1 plate

Open in Bambu Studio

Boost

Released

Description

Bambu Riser

Overall material consumption is 900 grams, and no supports are needed for any of the components.

There is a groove on the top of the RISER with a glass plate, with a tilt angle to ensure that the glass plate will not fall off.

The Build Plate Holder is locked in place with a clip.

The spacer is also locked in place with a clip.

In addition, a short version of the RISER is provided for selection.

riser

bambu

p1s

Comment & Rating (3)

@bambamprint

Thank you for the riser. I really do love the organic design. I did however run into a few issues. 1. The pegs are too small and fall out of place easily so I increased the size to make them fit snugly. 2. The entire print ended up being about 1/4" too small around the front and 1 side so it doesn't fit tight along the top of my P1S. The riser size is fine as the glass fits perfectly. Did you design the riser small on purpose for some reason?

The designer has replied

@SSSR_SH

The reason I made it slightly smaller is because I was worried about the precision of the sheet metal possibly being off, so I reduced the size a bit. Thank you for using it.