Search models, users, collections, and posts
Gridfinity USB-C Holder
IP Report
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
28 min
1 plate
A1 Mini - 0.2mm layer, 2 walls, 15% infill
33 min
1 plate
Slide in magnets mod - no glue magnets
27 min
1 plate
Open in Bambu Studio
Boost
159
682
55
18
1 k
609
Released
Description
USB C holder for a 1X1 Gridfinity. Holds up to 8 USB drives. Spacing is wide enough to hold most flash drives or adapters. Designed this to replace my old non-gridfinity holder that I have used for many years.
Slight taper in the pockets, to help lock in the USB devices when inserted. Slightly oversized for a snug fit, without being too tight.
Print with the gridfinity base down. I normally use supports for the magnet holes. Any layer height should work, I use 0.2mm.
Need USB C instead? Check this out: https://makerworld.com/en/models/75438#profileId-79954
Need USB A & USB C? Check this out: https://makerworld.com/en/models/75457#profileId-79963
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (55)