Search models, users, collections, and posts
Gridfinity USB-A & USB-C Holder
IP Report
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
29 min
1 plate
A1 mini profile, 0.2mm layer, 2 walls, 15% infill
31 min
1 plate
Slide in magnets mod - no glue magnets
23 min
1 plate
Open in Bambu Studio
Boost
451
1977
273
49
3.2 k
2.2 k
Released
Description
USB A & USB C holder for a 1X1 Gridfinity. Holds up to 4 USB A drives and 4 USB C drives. Spacing is wide enough to hold most flash drives or adapters. Designed this to replace my old non-gridfinity holder that I have used for many years.
Slight taper in the pockets, to help lock in the USB devices when inserted. Slightly oversized for a snug fit, without being too tight.
Print with the gridfinity base down. I normally use supports for the magnet holes. Any layer height should work, I use 0.2mm.
Need USB C instead? Check this out: https://makerworld.com/en/models/75455#profileId-79961
Need USB A instead? Check this out: https://makerworld.com/en/models/75438#profileId-79954
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (273)