Search models, users, collections, and posts
Flashlight GoPro clip for Wurkkos FC11
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
44 min
1 plate
Open in Bambu Studio
Boost
30
49
2
3
64
30
Released
Bill of Materials
List other parts
- Gopro-clip-mount x 1: Quick_release_buckle
Description
This clip can be used to hold a Wurkkos FC11 flashlight, and is intended to interface with a GoPro clip mount.
I printed it in PETG for extra strenght and impact resistance, but PLA should be fine too. Optionally supports can be used to support the tab curve, but this may not be necessary depending on your printer.
Model shown in the pictures was printed on a Wanhao i3 plus with wet PETG, this will come out much cleaner on any newer printer.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)