A1 AMS upper-mounted device- A1 AMS上置装置

This model has been redesigned. Please go to download the updated model.

MingGY | 已发布 - MakerWorld

这是为拓竹 A1 设计的 AMS lite 上置安装装置。设计简约牢固，采用 ABS 耗材打印。目前已在我的 A1 上安装使用超过 60 小时，毫无问题。
与官方发布的 AMS lite Top Mount for A1 相比，我的设计模型分件更少，打印时长更短，更易于打印，安装也更加简单。

所需五金：8 颗 3×12mm 自攻螺丝，5 颗 3×16mm 自攻螺丝。

推荐使用长度在 850 毫米至 900 毫米的 PTFE 管。

打印提示：为确保可靠的打印效果，推荐使用 ABS 耗材打印。使用 PLA 或 PETG 打印的结构强度未经验证，大胆尝试者希望在 500 小时后反馈装置是否牢固。为保证打印模型的结构强度，请勿在切片软件中改变首层面的朝向。

This is an upper-mounted installation device of AMS lite designed for Bambu Lab A1. The design is simple and firm and is printed with ABS consumables. At present, it has been installed and used on my A1 for more than 60 hours without any problems.
Compared with the officially released AMS lite Top Mount for A1, my design has fewer model parts, shorter printing time, is easier to print, and the installation is simpler.
 

Required hardware: 8 self-tapping screws of 3×12mm and 5 self-tapping screws of 3×16mm.

It is recommended to use PTFE tubes with a length ranging from 850mm to 900mm.

Printing tip: To obtain reliable printing results, it is recommended to use ABS consumables for printing. The structural strength of printing with PLA or PETG has not been verified. For those who are bold enough to try, it is hoped that you can feedback whether the device is firm after 500 hours. To ensure the structural strength of the printed model, do not change the orientation of the first layer in the slicing software.

Printing Tips: As some parts of the model have a small contact surface with the heated bed, they may detach from the heated bed during the printing process. To increase the printing success rate, please clean the printing plate with dish soap and spray glue before printing. Using a low - temperature warming printing plate can significantly enhance the printing success rate.

Feel free to leave a comment if you have any suggestions or questions about the model. When problems occur, please tell apart whether the issue is caused by the model itself, the printer, the filament, or improper operation and installation on your own part. I will block users who blindly attribute printing failures to the model and leave a one-star rating simply because they are unable to troubleshoot and fix problems by themselves. Such behavior greatly undermines the efforts of open-source creators.

有任何关于模型的建议或疑问，欢迎评论留言。出现问题时，请先区分原因：是模型本身、打印设备、耗材，还是个人操作与安装不当造成的。对于自身没有排查和解决问题的能力，却一味将打印失败归咎于模型并给出一星差评的用户，我将进行拉黑处理。这类行为会严重辜负开源创作者的心血与付出。