SlipperySalmon

cover

2024-10-11_k0mmue985ygo.jpg

plate_1.png

img-0197.webp

0.2mm layer, 6 walls, 25% infill

Joy&Enjoy

vacuum.jpg

body.jpg

head.jpg

inside.jpg

Please note that this configuration is only suitable for PLA material.I set the model to print horizontally to prevent the top section from collapsing and to avoid the lack of Z-axis strength in the narrower sections when printing vertically.I also adjusted the print parameters, reducing the number of layers and increasing the support support for horizontal printing. You can increase the distance between the supports and the nozzle to make them easier to remove. Removing the supports requires a knife, tweezers, and needle-nose pliers. The final print is shown in the photo. If you&#39;re a perfectionist, polish it with sandpaper. Otherwise, it fits perfectly with my Milwaukee M18 vacuum cleaner.

horizontal 0.2mm layer, 3 walls, 15% infill

Similar to Milwaukee 49-90-2037. Sized for the Fuel 2.5 gallon Packout Vac, but I imagine this would fit other Milwaukee vacs. Print standing up, no support. Use a ½&#34; (OD) vinyl hose, will be tight to install but will fit.

Milwaukee Air-Tip Extended Reach Vacuum Attachment

ASIA

Print Profile(2)

Description

Comment & Rating (43)

License

Related Models