Clapper Board|Film Slate - Print in Place
Print Profile(1)
Description
This is a print-in-place Clapper Board or Film Slate with a built-in storage compartment!
The filament should be swapped after layer 110 (layer height 0.2mm) to achieve the dual color effect.
The model includes a space to place magnets mid-print. The magnets I used are 15mm in diameter and 3mm in height. To insert the magnets pause at layer 92 (layer height 0.2mm).
All the hinges are print-in-place therefore for good results, the board should be printed lying flat.
Supports are only needed in the inside of the storage compartment.
If you have any suggestions for improving the model or some changes you would like to see, leave them in the comments.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (23)